Plant-Profile about AutoBlackberry Kush (by Dutch Passion)
This Plant-Profile was generated by 1 single profiles, particular thanks goes to: OldeSchool
Information about the growth of the plants:
- Flowering Time Indoor
-
Between 70 and 70 days (Average: 70)
- Stretch after the initiation of flowering
-
±50 Percent
Initial of flowering onto around 30 cm. - Final Height onto around 45 cm.
- Growth Behavior
-
Lanky and Sickly
- Side Branches
-
less to average
;
slightly above average length
as well as
below average strongness
- The plants of this Cannabis-Strain...
-
-
...do not need much care.
-
...do not need much fertilizer.
-
...are tolerant of temperature fluctuations.
-
...have no problems with low temperatures.
-
...have no problems with high temperatures.
-
...looks and grow more like a Sativa.
-
...are well suited for very low growrooms.
-
...should not be heavily pruned.
-
...build hardly ordinary buds on the side branches.
-
...can build pre flowers into the growth period.
Harvest, Yield, Taste, Aroma, strength and effectiveness
- Yield / Quantity
-
The crop of this strain is not very good
- Buds / Leaves
-
The ratio of buds to leaves is very good
- Bud Structure
-
The dried buds are rather fluffy
Effect/Effectiveness
Smell / Aroma
No data available for this strain.
Taste
No data available for this strain.
General Impression
AutoBlackberry Kush (Dutch Passion) (Indoor) is all together there are much better strains
(On average 3 Points onto a scale between 0 and 10!)
Additional Information
OldeSchool says
Grow environment was 4 sq. ft. tent, 250W HID sealed cooltube reflector & 170CFM fan, another 170CFM connected to Phresh carbon filter. single plant four gallon ebb n' Gro pot flooding every two hours using a custom version of General Hydroponics' expert recirculating formulation. pH maintained between 5.8 and 6.1; ppm between 970 - 1030 （500 scale; EC 1.9 - 2.1 if you prefer）. Nutrient strengths included addition of Cal-Mag to RO water at 4mL / gal （about 250 - 300 ppm with 2 mL / gal. silicon added before any actual nutes）. Tent temps maintained at 60 （lights out） to 80 F （toward end of on-cycle）; typically staying in 65-75 F range. Reservoir temps stable around 68 - 72F.
I was REALLY excited about this plant as it grew. Early into the veg cycle it started developing what looked like BLACK centers in all leaf clusters. As it aged and started showing flowers, the color spread until the entire bud cluster appeared black. As the buds developed, the black transitioned to purple, and was one of the most beautiful strains I have ever grown. HOWEVER - as the plant matured, the calyxes opened up, and by harvest they were quite fluffy. As the buds dried and cured, they became even LESS dense, and lost most of whatever poor flavor it had earlier in the drying / curing cycle. As curing progressed, no moisture came back and very little flavor. The wispiness of the buds should be the cause of this IMHO.
Altogether, it is a BEAUTIFUL plant to grow （will post pic if I can get that to work）, and the smoke quality is very good - 8 of 10? But bag appeal suffers with wispy buds, taste is subpar, and the yield is very poor - 4 oz. cured, when I am used to 6.5, 8, up to 12 oz per plant in my past grows using same tent / light system.
Before I would grow this again I would have to see more than one grow report that conflicts with mine. I can say, the plant is calcium-hungry. Halfway through bloom I started seeing calcium deficiency signs that went away when I increased Cal-Mag to 4mL / gallon. And the post-harvest root ball showed less root development than I'm used to seeing, a side effect of calcium deficiency. So benefit of the doubt would be extended if someone can document better results with particulars of their grow environment.
Here you can have a look onto the single Plant-Profiles:
Single Plant-Profiles about this strain was uploaded by: OldeSchool
SeedFinder Strain Reviews
This Strain-Profile is an average out of all Plant-Profiles who was uploaded by our users. If you also have grown this strain before, please use our upload-form to expand and update this data! Its fast and easy, you only have to check some boxes, but it will help us a lot to fill up our database and standardize the strain-descriptions. And later we can integrate some options to search or sort this data, too!